MustangWorks.com : Ford Forums - View Single Post - Cam gurus- need your opinion

RobertD · 05-12-2001, 01:03 PM

My new motor will be a GT-40P long block from CCM. I'll be running a off-road exhaust. The car is an AOD with the stock converter and a TransGo shift kit. The rear houses 3.27 gears.
I called Com Cams and they recommended a cam with the below specs...

Int - 206* @ .50 with a lift of .533
Exh - 206* @.50 with a lift of .533

The lobe seperation is 112*.

I need to know whether to go with this or the stocker. Supposedly the above cam has a very fast ramp rate and will give me excellent low end torque. The car will be driven only under 5K rpms. Isn't this cam a little weaker than stock?

------------------
Robert
91GT; 88 ASC McLaren #709

05-12-2001, 01:03 PM	#1
RobertD Registered Member Join Date: Jun 1999 Location: El Paso, Texas, USA Posts: 170	Cam gurus- need your opinion My new motor will be a GT-40P long block from CCM. I'll be running a off-road exhaust. The car is an AOD with the stock converter and a TransGo shift kit. The rear houses 3.27 gears. I called Com Cams and they recommended a cam with the below specs... Int - 206* @ .50 with a lift of .533 Exh - 206* @.50 with a lift of .533 The lobe seperation is 112*. I need to know whether to go with this or the stocker. Supposedly the above cam has a very fast ramp rate and will give me excellent low end torque. The car will be driven only under 5K rpms. Isn't this cam a little weaker than stock? ------------------ Robert 91GT; 88 ASC McLaren #709