MustangWorks.com : Ford Forums - View Single Post

anyone heard of putting a waste gate on a supercharger? i know its done all the time for turbos and it would be alot easier then changing pulleys all the time to run pump gas on the street

__________________
88 Conv Vortech S-trim 2.5" 10-rib pulley, 332 stroker w/ Cat forged crank, forged JE flat-tops, forged rods, 10.25:1 comp, DSS girdle, edelbrock heads, Omega valvetrain, Lunati custom cam, extrude honed Cobra intake, 70mm T-body, Pro-M 77, bypass valve, dual Walbro 255 lph in tank pumps, an -8 fuel hose, aeromotive fuel rails/regulater. 42# inj, MSD ingniton/boost retard, JBA headers, flowmasters, full Griggs GR-40R suspension (K-member, torque arm, panhard bar, subframes, strut brace) Centerforce clutch, Tremec, Auburn posi locker, moser axles, Baer brakes/rotors, 17" cobra R wheels, custom body/roll bar

06-25-2002, 12:24 PM	#1
keakua Registered Member Join Date: Jun 2002 Location: phoenix, az Posts: 20	blower waste gate? anyone heard of putting a waste gate on a supercharger? i know its done all the time for turbos and it would be alot easier then changing pulleys all the time to run pump gas on the street __________________ 88 Conv Vortech S-trim 2.5" 10-rib pulley, 332 stroker w/ Cat forged crank, forged JE flat-tops, forged rods, 10.25:1 comp, DSS girdle, edelbrock heads, Omega valvetrain, Lunati custom cam, extrude honed Cobra intake, 70mm T-body, Pro-M 77, bypass valve, dual Walbro 255 lph in tank pumps, an -8 fuel hose, aeromotive fuel rails/regulater. 42# inj, MSD ingniton/boost retard, JBA headers, flowmasters, full Griggs GR-40R suspension (K-member, torque arm, panhard bar, subframes, strut brace) Centerforce clutch, Tremec, Auburn posi locker, moser axles, Baer brakes/rotors, 17" cobra R wheels, custom body/roll bar