1/4 Mile Guestimate? :)
I know it is always hard to say, but would would you guess I woudl run with the following setup (assuming I hook up well)? Working on my car and this is what I should have when I am done with this project.
What do you think I would run with a headswap (willing to pay ~1000 on pair of heads w/o install)? Thanks.
1990 Red Mustang 5.0 LX:
Manual Transmission (yay)
BBK X-Pipe
Traction Bars
MAC Cat-Back Exhaust
MAC Cold Air Intake
BBK Shorties
3.73 Gears
Cobra Intake Manifold (Upper and lower...)
B-303 Cam
Granetelli Mass Air Flow Sensor
Timing at 16*
Font and rear sway bars
Drag Radials
Some other suspension stuff.
__________________
What I have:
1990 Red Mustang 5.0 LX:
[BBK X-Pipe]-[MAC Cat-Back Exhaust]
[MAC Cold Air Intake]-[BBK Equal Shorties]
[3.55 Gears]-[Cobra Intake Manifold (Upper and Lower]
[E-303 Cam]-[Granetelli Mass Air Flow Sensor]
[Front and rear sway bars]-[New black carpet and seats.]
[Adjustable Fuel Regulator]-[T5 Conversion w/ K. Cobra Clutch/Hurst STS]
[Cobra Throttle Body]-[130A Alt. Conversion]
Thinking about:
Aftermarket Heads!
Vortech A-Trim
|