[Ieatcamaros]

It's been so long since I have looked at one, I couldn't tell ya which wire goes where. Are you sure you have good connections? Loose or dirty ones will hardly work.

I don't know if you can test the pick-up coil or not. I do know that you have to pull the distributor and pull the gear off to change it.

As for the inertia switch, try hotwiring it just to be sure it isn't that. Pull it out and take the electrical connector out of it. Put a paper clip or piece of wire and loop it from one side of the electrical connector to the other. This is done on the wire connecting to the switch, not the switch. Turn the key on, if you don't hear the fuel pump prime, then that is not the problem. You have a firing issue not fuel. And my first suggestion is the pick up coil.