View Single Post
Old 08-09-2002, 08:40 PM   #8
PKRWUD
Junior Member
 
PKRWUD's Avatar
 
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
Default

Okay, you have a few things you need to do, and you need to do them EXACTLY like I tell you to, and in this exact order:

First, buy a can of electric contact cleaner, and unplug the MAF at the harness and thoroughly clean the contacts, then reconnect it.

Second, disconnect the negative battery cable, and then turn on your headlight switch. After ten minutes, turn the switch off, and reconnect the battery.

Third, Start the engine, and warm it up for 10 minutes. Drive the car to the end of your block, and turn so you're facing home. Put the tranny in low gear, and accelerate HARD to 25 mph, and then coast the rest of the way home. Shut off the engine, and run the KOEO codes again, and post your results.

Take care,
~Chris
__________________
Webmaster:
Rice Haters Club
Jim Porter Racing
Peckerwoods Pit Stop


Support Your Local
RED & WHITE!
PKRWUD is offline   Reply With Quote