Fuel gauge
I just got my fuel level gauge mounted in the pillar. Now I need to wire it up. Can I use the wires from the factory gauge cluster or do I have to run new wires?
It looks like either way will be about the same amount of work, but if I have to remove the gauge cluster, I might as well send of my speedo now (I have 3 spares) to get the white face gauges and 140MPH conversion.
__________________
Engine:
1990 5.8 / Edelbrock Performer set-up
MSD ignition
Suspension:
Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors /
Drivetrain:
Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel /
5.8 in the hole
|