It is a heat shield, I can't find it on pro-m's website, I am not sure if it is made by them.
Does anyone know of a "airbox" or shield that I can buy to fit a 12 inch K&N filter that is similiar to the one pictured?
Will 1/8inch thick sheet styrene melt under the hood? I can mold a cover out of it that will do the same job.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway
-1994 Ranger w/ 427cid windsor (daily beater)
check it out!
Last edited by RPM427; 08-26-2002 at 12:43 PM..
|