Thread: pulleys
View Single Post
Old 09-06-2002, 12:13 PM   #17
Agent_4573
Registered Member
 
Join Date: May 2002
Location: New Jersey
Posts: 375
Default

I put a set of bbk underdrive pulleys on my car and have only had one problem with them and it was an isolated case. My car charges about 12 volts at idle, and anywhere from 12-18 volts crusing around town(1500-6000rpm) I put in an electric fan and still don't have a charging problem. (well ok, when the fan didn't turn off the one time, my battery died). I guess every car does react diffent but mine didn't need the 130 amp alt. Granted though, about 1 month before the pulleys the alt went bad and i had to put in a new one so i guess you have to conside the fact that it is a new alt. I would say get em and just switch back later if you have a problem... you can always sell them again. Now i have to go replace my head gasket...
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression.

If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout.

RICER HATERS CLUB MEMBER 87!
www.ricehatersclub.com
Agent_4573 is offline   Reply With Quote