View Single Post
Old 09-09-2002, 07:02 PM   #1
LS WHAT
Registered Member
 
Join Date: Sep 2002
Posts: 4
Default Please Help!!!!!!!!

Hello all. I This is my first post and I've come to get help on a serious problem. I just got done doing a H/C/I swap on my 88 lx. I ran it for a couple days on speed density then converted over to mass air using ITS harness, A9P used from MPS, and a 75mm bullet. The car breaks up and stutters anything after half throttle. Also the power is way down. Here is some food for thought: new coil, O2 sensors, ACT & ECT sensors, checked MAP sensor, HEGO ground is connected to block as is the other ground strap to the back of the head, 17 degrees of timing, 12 in of HG at idle, 35 lbs of fuel pressure( tried other settings but really didn't affect it), clocked MAF, swapped MAF with a buddies cal'd for 30#'s, got .68 volts between C&D and 12.5 between A&B on MAF. MAF wiring is OK, got code 66(low MAF signal voltage) KOEO, I have a different computer coming to see if it's that. the plugs sre rich but not on top. I'm completely stumped here.

Any ideas would be greatly appreciated.

Thanks, Matt
__________________
1988 mustang lx 5.0

Trick Flow Twisted Wedge Heads, Trick Flow Street Intake, Crower 15511 Cam, Pro-M 75mm bullet, Mass Air Conversion, Mac 70 mm t-body, 30 # injectors, 255lph fuel pump, NOS stage 1, 1.72 Scorpion Rockers, BBK shorties, Mac offroad h-pipe, 2 chamber Flows, AOD w/Transgo shift kit, 3.73's
LS WHAT is offline   Reply With Quote