MustangWorks.com : Ford Forums - View Single Post

06-15-2001, 12:43 PM

Putting my motor together this weekend... just pulled the new intake out of the box and there is quite a bit of casting irregularity in the ports..

I was thinking of taking a dremel and CAREFULLY cleaning them up..

how far into the port should I go?? any other suggestions??

------------------
Black, 84 GT, T5, ground effects, shorty headers, dual exh., rear spoiler from a 87.. In the works; 4:10's, 89 ported heads, edelbrock Performer, matched cam and holley carb (?? size)

06-15-2001, 12:43 PM	#1
jerryIII Guest Posts: n/a	home intake porting Putting my motor together this weekend... just pulled the new intake out of the box and there is quite a bit of casting irregularity in the ports.. I was thinking of taking a dremel and CAREFULLY cleaning them up.. how far into the port should I go?? any other suggestions?? ------------------ Black, 84 GT, T5, ground effects, shorty headers, dual exh., rear spoiler from a 87.. In the works; 4:10's, 89 ported heads, edelbrock Performer, matched cam and holley carb (?? size)