MustangWorks.com : Ford Forums - View Single Post

jerrys84 · 10-17-2002, 04:49 PM

I realize this is a mustang board, but i can't find anywhere alse that's worth the trouble..

I have a 91 bronco 4x4 302 EFI, I installed a plow on it today.

my problem, after completing the work, i went to start it and all it does is turn over.. the fuel pump does'nt turn on.. I can hear the relay switch turn on and then off, but the pump won't run... everything worked fine this morning. I've checked everything i've touched.. I did run the battery low while adjusting the plow pump, but now it's fully charged...

Is there a fuseable link?? where/ what can i check??

I assume the pump in the tank, if it's the pump, can i install an aftermarket pump outside the tank without removing the factory pump?? Can i run a hot wire to test the pump??

any help is appreciated.. I am so confused........

10-17-2002, 04:49 PM	#1
jerrys84 Registered Member Join Date: Feb 2002 Location: minnesota Posts: 129	91 bronco 302 fuel pump question I realize this is a mustang board, but i can't find anywhere alse that's worth the trouble.. I have a 91 bronco 4x4 302 EFI, I installed a plow on it today. my problem, after completing the work, i went to start it and all it does is turn over.. the fuel pump does'nt turn on.. I can hear the relay switch turn on and then off, but the pump won't run... everything worked fine this morning. I've checked everything i've touched.. I did run the battery low while adjusting the plow pump, but now it's fully charged... Is there a fuseable link?? where/ what can i check?? I assume the pump in the tank, if it's the pump, can i install an aftermarket pump outside the tank without removing the factory pump?? Can i run a hot wire to test the pump?? any help is appreciated.. I am so confused........