Well right now im planning on getting tfs track heat heads and have them ported... I also plan on getting the track heat intake (im not sure about getting it ported though?) I am also going with 42lb injectors. And getting a custom cam from anderson ford motorsport.
I will put a 255 lph intake fuel pump... Im not sure if i will need another inline pump closer to the engine or not. My short block is made from scat crank, scat rods, and probe pistons.
So i hope i can make 375 with my 331... I think i shouldn't have much of a problem with that setup?
I already have a chip that can and has been reburnt before.
Any comments?
|