Quote:
Originally posted by 95mustanggt
My wife's stereo system was causing her some greif, and there was this 1000W AMP for CDN$150. So I bought it. (I also picked up an 800W 2/3/4 channel for my stang  )
Anyway, I'm wiring the system in and here's how it goes...
Deck - Pioneer 2X45W's are driving the rear 6X9's.
1st Amp - Alpine 2X25W is driving the front 4" doors speakers
2nd AMP - Sony 1X300W is for a 12" Sound Stream Sub.
I have connected it as follows:
I have a few questions
1. (More of a comment) I am going to swap out the 30A fuse to an 80A as the directions on the SONY AMP. Is this going to harm the Alpine?
2. I have this "remote" wire going from the deck then split to each amp. Without this wire neither amp will work. Is is OK that I have it split to each amp like it is?
3. Everytime I turn on the car the sub goes blahhhhhhh (kind of a high-low tone and then the fuse blows (30AMP). Is this just because the 2 amps are drawing way more than 30A and I NEED the 80A fuse?
4. Screw-ups noted in my wiring diagram?
Thanks guys.
|
1. Each cicuit should have its own fuse. Redo that circuit
2. like OG says, it is just a signal wire. you can have 5 amps hooked to that signal wire if you wanted.
3. Again, like OG says, make sure you dont have a shorted wire. Also make sure you dont have a "switched" ground for your amps.
4. 2 things. you are sharing a fuse with 2 different accesories. also like
OG said, you dont ground the speakers to the car ground! that is a big no no! that could also pop a fuse!!!
let us know!