MustangWorks.com : Ford Forums - View Single Post

11-05-2002, 06:08 PM

I'm not a 100% sure, but I think that the E-303 cam is the only one out of the three that you mentioned, that you can use without needing your pistons fly cut. I run the B cam w/ 1.72 rockers and love the set up. My motor pulls hard from 3000-6000rpms. My pistons have been cut though, during the build up of my current motor.

11-05-2002, 06:08 PM	#5
Simi Stang Guest Posts: n/a	X, B, or E?? I'm not a 100% sure, but I think that the E-303 cam is the only one out of the three that you mentioned, that you can use without needing your pistons fly cut. I run the B cam w/ 1.72 rockers and love the set up. My motor pulls hard from 3000-6000rpms. My pistons have been cut though, during the build up of my current motor.