I seen this procedure performed on "Horsepower TV" they loaded up a drill bit with vaseline to drill the hole and all of the shavings stuck to the vaseline and then they used a tap with vaseline on it also it seemed to work pretty well. After they were through with the install they changed the oil just to make sure that there were no shavings in the pan.
------------------
88 mustang gt convertible bored to 306 BBk equal length headers mac cold air fender kit cowl hood nitto drag radials ford racing clutch flow masters h-pipe 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs.
best 60 ft 2.14, best 1/8th 9.65, best 1/4 15.2 @89mph, Stock gears and 3000+ Altitude
|