Cam Bearing
Is there a special tool needed to remove the cam bearings?
I have the engine block bare and it has some surface rust at the top two inches of the bore, very fine. If I hone it smooth and measure it, how far can you go before having to bore it up a size? If I confused anybody let me know?
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse.
1966 Mustang still in progress
|