MustangWorks.com : Ford Forums - View Single Post

90muustanggt · 01-21-2003, 10:39 PM

IF im not mistaken i think drudis's is a custom setup. I have seen a few others with a similar setup though. For subframes i know that a few people will make custom pipes with notches in them that hump over the subframe. Just because that some company says that it won't fit dosent mean that it can't right?

Just have a section welded in to bypass the subframe and your set.

01-21-2003, 10:39 PM	#2
90muustanggt Registered Member Join Date: Jan 2003 Location: Fairfax, Va Posts: 3	IF im not mistaken i think drudis's is a custom setup. I have seen a few others with a similar setup though. For subframes i know that a few people will make custom pipes with notches in them that hump over the subframe. Just because that some company says that it won't fit dosent mean that it can't right? Just have a section welded in to bypass the subframe and your set. __________________ *SN November 2002 PS Bronze winner* -------------------------------------------- 90muustanggt.cjb.NET ------- fox3swap.cjb.net ------------ Engine: Underdrive pulleys Comp Polymers Upper intake Crane Cams Hi-6 Ingnition Drivetrain: FMS aluminum driveshaft Steeda Adjustible Clutch cable Pkg. FMS Cobra Clutch Brakes: Sn95 Conversion with 99+ PBR Calipers(visit fox3brakes.cjb.net for more info) ABS Soon! Suspension: H&R springs - 400lb. front 375lb. rear Tokico illuminas with front coilover kit from D&D MM CC Plates D&D Tubular front suspension Custom subframe connectors Granatelli Adjustible LCAs FMS Upper control arms Steeda STB Many more mods but most are pointless to list.