N2O options?
Ok...this is just me looking ahead for my project. I just bought a new car so I'm putting an injected aluminum headed stroker motor in the Mustang during the summer. It'll run between 375-400hp NA and I'm looking for about 125hp or so worth of N2O (did I mention I'll have a main girdle?). Should I get a dry system or go with a wet system? I'll be using at least a 190lph fuel pump with (probably) 30lb injectors with a programable DFI system. Wet systems always seemed more complex but have the safety factor of adding fuel with the nitrous. Although, i'm aware of that fuel's capability to puddle in the manifold, so a plate system is the only option there. Dry systems seem easier to hook up but will my fuel system be able to hold up? Being the enormous f!@king geek that I am, I've read up as much as I can about it (and I work in a book/music store, so that's a lot of stuff) so I know all the theory and whatnot. I also know that a bottle warmer, pressure gauge, and remote valve opener are mandatory. On a sidenote, anyone know where you can get one of those arming switch panels like they used in "Gone In 60 Seconds"? You know, the one with the covered toggle switch and the LED light marked "armed"? That thing looked bad@ss.
------------------
1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s
|