MustangWorks.com : Ford Forums - View Single Post

gtsr515 · 02-10-2003, 08:44 PM

Did you replace wheel bearings too, is that it maybe?, how about the low pad indicater bent and scratching the rotor when you load the car on a right hand turn? it happens even though the pads are new, try to "Bed" the pads a little , make a few hard high speed stops, not enough to warp the rotors, but get some heat in 'em and see what happens.......

Good luck, Camaro's suck!

Jay

02-10-2003, 08:44 PM	#2
gtsr515 Registered Member Join Date: Nov 2001 Location: Sunny, Hot, Sebring, Florida Posts: 725	Brakes Did you replace wheel bearings too, is that it maybe?, how about the low pad indicater bent and scratching the rotor when you load the car on a right hand turn? it happens even though the pads are new, try to "Bed" the pads a little , make a few hard high speed stops, not enough to warp the rotors, but get some heat in 'em and see what happens....... Good luck, Camaro's suck! Jay __________________ Remember...2nd place is 1st place for losers!