View Single Post
Old 04-04-2003, 11:32 AM   #1
Miss Mischief
Registered Member
 
Miss Mischief's Avatar
 
Join Date: Feb 2003
Location: Still Ugly as ever
Posts: 111
Default Brakes On a 2000 V-6

Ok this May sound very stupid

But i Understand the principals Of Corner Carving is Gears and Gas. Brakes are not something I ever worried about In a Car Built for powering through a corner because I would never gear out until I was through a turn and Had gotten a Little Tach this way if she started to slide or loose grip slipping of the gas is more likely to bring her back then a Tap of the Brake. But How inportent is it to have any Better calipers and Discs Then what come with the V-6 Pony? She has 4 wheel ABS as well as 4 wheel dual caliper disc brakes.

The way I have always seen It Brakes to a Corner Carver are very bad Because Like a High Horespower Engine with no Throttle Band the car simply wants to drive straight vrs turning.
__________________
Miss Mischief

RHC#153 Proud to carry the Card

2000 V-6 5 speed Frame Braces [Steeda] [Wanna be Cobra] 17" Rims with Kuhmo 245's 5 Spoke Gunmetal finish [Power Dyne] Blower Unpolished 6 psi {Mods to Come} [Steeda] Springs slightly lower then stock [Steeda] Anti sway bars front and rear.

1999 Jeep Cherokee Big six 5 speed Infinty Bose steroe Lots of Creatures Comforts [Mods] Brush/ Push bar Full length Welded and Bolted , Tow Hook Front and Rear 30" Goodyear AT's .
Miss Mischief is offline   Reply With Quote