I went through all sorts of problems when building and installing my motor. First the crank wouldnt fit. Then I had to have the bottom of the cylinder walls but. Then my starter locked up. Then my buddy stole my mass air meter and air filter. Theres always going to be problems!
After I had it installed I had a horrible flooding problem, then heating problems, now I have blew out most of my accessories!
Good luck on getting it running!
------------------
347 Stroker Motor: Balanced, Cobra Transmission, Extrude Ported and Polished Upper and ported Lower, GT40 Milled Ported and Polished Heads, B303 Cam, BBK 1 5/8 Headers, 30lb Bosch Injectors, Holley AFPR, March Underdrive Pulleys, Perma-Cool Fan, 3-Core Radiator, Accel Performance Coil, Accel 300+ Racing Wires, Ram Air, K&N Filter, 73mm Vortech MAF, 70mm TB, FlowMaster Exhaust w/BBK Offroad H-Pipe, Hurst Shifter, 3:55 Gears, Ram Clutch, Cross Drilled Rotors, AC and Smog del, rear seat del.
[This message has been edited by Smokedawg (edited 07-23-2001).]
|