MustangWorks.com : Ford Forums - View Single Post

RPM427 · 06-23-2003, 02:08 PM

I start my car thismorning and i hear a tapping noise, and it goes away when I push in the clutch. So I take off the cover on the bellhousing, where the cable goes into it and take a look. Everything looked ok, so i start the car and take a look. The throw-out arm it moving all over the place, and was hitting the cover. I can also see the clutch itself moving as well. Is it possible the bolts holding the clutch on the flywheel came lose? Could it be the throwout bearing? What are some possible cuases of this?

06-23-2003, 02:08 PM	#1
RPM427 Registered Member Join Date: Aug 2001 Location: Huntington NY Posts: 573	Clutch help needed!! I start my car thismorning and i hear a tapping noise, and it goes away when I push in the clutch. So I take off the cover on the bellhousing, where the cable goes into it and take a look. Everything looked ok, so i start the car and take a look. The throw-out arm it moving all over the place, and was hitting the cover. I can also see the clutch itself moving as well. Is it possible the bolts holding the clutch on the flywheel came lose? Could it be the throwout bearing? What are some possible cuases of this? __________________ -1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out!