Got the pin out no problem. Old Guy...did you use a 3 position toggle? How did you wire it? I've been trying to imagine where the primary signal wire for the sensor goes on this switch and I can't visualize it. I imagine both ECM input wires going to opposite sides of the switch...is there a third connector on the switch for the gauge then, which, depending on the switch position, completes the connection with either the 29 pin or the 43 pin?
__________________
'91 Mustang GT 5.0 AOD Daily Driver
Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI
13.73 at 103.8, ~2.2 60'
|