View Single Post
Old 11-25-2003, 03:13 PM   #1
blue00gt
Mustang Addict
 
blue00gt's Avatar
 
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
Default Spec flywheel, clutch, and FR driveshaft

Well, my stock clutch finally started slipping after 56k hard miles, so I just put a Spec stage II clutch with lightened pressure plate, aluminum flywheel, and Ford Racing aluminum driveshaft on the car. Pedal effort is slightly heavier than stock and the clutch starts to grab with the pedal close to the floor now instead of halfway out. The difference is very noticeable, not just from a shifting standpoint but even during acceleration with the clutch all the way out it winds up quicker now. In 2nd gear I can be driving along at 3-4k rpms and if I roll into the throttle too fast it breaks 'em loose. That never used to happen in 2nd, only 1st. It also rev matches beautifully now.
No problems with the throwout bearing, chatter, or pedal vibration either.
__________________
Strike down the unroadworthy!
2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more
'94 Rio Red Cobra: All the bolt-ons, 3.73s
blue00gt is offline   Reply With Quote