MustangWorks.com : Ford Forums - View Single Post

fastang · 12-08-2003, 09:50 PM

If you could kindly post pics of your cars and tell me which springset you are using and whether or not you like it I would greatly appreciate it.

Im looking for a set that will drop the car about 1&1/4 inch and that will not leave the front sitting higher than the rear. I really dont want to have to buy the caster/camber plates either so if that can be avoided without hurting the car it would be a plus.

I really dont want it to ride rough either:)

Thanks guys. You have always been very helpful here. Jesse

12-08-2003, 09:50 PM	#1
fastang Registered Member Join Date: Aug 2000 Location: santa ana ca Posts: 1,349	Pics of your car? If you could kindly post pics of your cars and tell me which springset you are using and whether or not you like it I would greatly appreciate it. Im looking for a set that will drop the car about 1&1/4 inch and that will not leave the front sitting higher than the rear. I really dont want to have to buy the caster/camber plates either so if that can be avoided without hurting the car it would be a plus. I really dont want it to ride rough either:) Thanks guys. You have always been very helpful here. Jesse __________________ 98 GT manual trans, Magna Flow exh. old car: 95GT, TFS T.W. heads, Holley Intake, B303 cam, FRPP 30lb injectors, Scorpion 1.6 rollers, 65mm TB, 73mm MAF, BBK Longtubes, Flowmaster cat back, March Pulleys, MSD coil, 9mm wires, Tremec 3550 trans, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors. 190lph pump, BBK adj FPR.