MustangWorks.com : Ford Forums - View Single Post - Need help trying to pass inspection tomarrow! Need to wire horn and rev. lights

Stang_ROTY · 08-17-2001, 06:15 PM

I have a 93Gt and need some help wiring the horn and rev. lights so I can make an attempt at passing inspection. I looked in the Chilton's manual and the thing was useless. I have an air bag, too. I have what looks like a horn mounted underneath the drivers side front end but there are no wires attached. I need the reverse lights cause that's mandatory for the safety inspec. and that should be a little easier. Thanks.

------------------
Finally DONE!!
93 GT, 393 stroker w/ Edlebrock Performer heads and EFI, 30lb injectors, Dynamic Roller Mite C4, 8 pt cage, Sothside Machine bars & Sub-frames, 3.73's, '69 351W block w/SCAT crank.

08-17-2001, 06:15 PM	#1
Stang_ROTY Registered Member Join Date: Feb 2001 Location: Berkshire County - Massachusetts Posts: 735	Need help trying to pass inspection tomarrow! Need to wire horn and rev. lights I have a 93Gt and need some help wiring the horn and rev. lights so I can make an attempt at passing inspection. I looked in the Chilton's manual and the thing was useless. I have an air bag, too. I have what looks like a horn mounted underneath the drivers side front end but there are no wires attached. I need the reverse lights cause that's mandatory for the safety inspec. and that should be a little easier. Thanks. ------------------ Finally DONE!! 93 GT, 393 stroker w/ Edlebrock Performer heads and EFI, 30lb injectors, Dynamic Roller Mite C4, 8 pt cage, Sothside Machine bars & Sub-frames, 3.73's, '69 351W block w/SCAT crank.