Need help with starting my 93 5.0 Bronco!!
I know this is not the right area but you guys seem to know alot about the 302 motor so please try to help with any information. I was driving my bronco for about an hour, arrived home and then parked it on the driveway. I go inside and get out of the -25 degree weather then later i come back out and try to start her up. I get nothing but the sound of the fuel pump and a click from the starter(i think) when i turn the key. so i try to jump it and it doesnt work, then i replaced the batt. and terminals and cleaned some connectors and tried again and all i get is this click from inside the engine compartment. I run the codes and just get three codes that adjust the sensors for the tempurtur. I know the starter is getting enough power and i hear it clicking, but it wont turn over. I turned the motor over easily with a breaker bar so i know the motor isnt locked. Now could a starter just go bad like that or would it be the silinoid? I replaced my starter in my mustang and i think it did the same thing that this did but i forget if it was a combanation of things or what. I need to go to the parts store and get the new part tomorrow, so any help is great! THANKS!
__________________
89' GT with 5spd Hurst short throw, Keith Black 12:1 comp. pistons, Sealed Power drag racing rings, Fms F303 Cam, Ported and polished upper and lower intake with Ported E7TE heads that contain comp. cam double coiled springs with titainum locks and steel retainers, Fel-Pro Head Gaskets, 9mm ford racing wires, BBK chrome unequal shortys, Power Throttle bodies 70mm, Edlebrock 70mm EGR plate, 15inch K&N, Bassani X-pipe, Flowmaster 40 series, Eibach 1 1/2 lowering springs, Cobra R rims 17X9 with p235 on front and p275 on rear with Falken Zeix tires-RUNNING!
|