Quote:
Originally posted by Ieatcamaros
What do you mean by this? What I want to do is put on this x pipe and bolt my existing cat back to it. Did you buy yours direct from dr gas?
|
The "flow tubes" are what I call that connects the muffler to the h-pipe.
You have an exhust tube that is approx. 12 inches long that bolts to the muffler. That tube also bolts to the h-pipe. In a cat back kit, you get two mufflers, two flow tubes and two turn downs or two tail pipes along with the bolts and nuts (hardware) and hangers.
When you get the x-pipe kit from dr.gas you will most likely get 4 long tubes (pre-bent) (which will also have to be cut down to fit)and the x-pipe junction. Two of the tubes will go directley to the mufflers. So you will have to remove the "flow tubes" that came with your original cat-back.
Or at least that is what had to be done with my 3 inch exhust.
And no I did not have to deal with Dr. Gas directly, you can speak with "Neil" at Dr. Gas if you want, or call Panhandle Performance for the x-pipe. (they are a direct dealer for them) And that is what I did.
Good Luck