View Single Post
Old 02-25-2004, 08:18 PM   #15
Hozer 88GTConv
Registered Member
 
Hozer 88GTConv's Avatar
 
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
Default I had to jump in...

I have the B with 1.7's (so I get the lift of an E, but the advertised duration of the B) TW heads (not to mention supercharged) and it idles as of three hours ago, via a Snap-on 1222 Engine Diagnostic Computer between 790 and 820 RPM.
I was checking my firing(electronic) efficiency via the O-scope readout and RPM variation per cylinder.
I do have the IAB spacer with a new IAB bought about a year ago. I also have a A3M with a JMS chip setup. I am nowhere near my hp potential on my combo even at 8 lbs due to my oil issue on number 5.
After correcting my oil issue, which I hope is a valve seal, I hope to net somewhere around 10 percent more on the dyno curve.
That's with a B-cam that idles rock steady.
Good Luck... (oh, I have 44 degrees of total advance via the Snap-on too...Trick Flow recommends 36 but oh well)
__________________
1988 GT Convertible
331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta...
One week with new motor, two speeding tickets...joy
Hozer 88GTConv is offline   Reply With Quote