View Single Post
Old 03-21-2004, 12:59 AM   #46
JBeryleC
Registered Member
 
JBeryleC's Avatar
 
Join Date: Jul 2003
Location: Sebastopol CA
Posts: 169
Default

If you look above you'll see that you should change out the pipe that runs from the throttle body to the maf.

check out densecharger.com and click on "ordering" then at the top click on "here"

You'll see the pipe you need there.
that'll give you a good gain.

The larger TB and plenum wont give you all that it can until you put a larger pipe in there too

But no you do not need a bigger MAF sensor.
__________________
Torch Red '02 GT Convertible 5 spd
BBK long tubes, BBK h-pipe, MAC mufflers, K&N w/ silencer trimmed, FRPP 70mm throttle body, C&L plenum, Mobil1 synthetic fluids, FRPP aluminum drive shaft, Steeda Tri-Ax shifter, FRPP 4.10's, 18x9 & 18x10 Saleens with Dunlop SP Super Sport Race rubber, Mach1 grill (GT delete), & Mach1 bumper chin!
Click here for pictures & more info!

If you are in Northern California, check out North Bay Mustang Club for local meets and cruises!
JBeryleC is offline   Reply With Quote