Valve cover question
I have a set of Motorsport aluminum covers, the tall ones with the red writing. I have a pcv valve in the drivers side cover, and a breather in the other one. The passenger side breather hits the drier and has caused dripping of oil onto the header. Do I really need the breather on the passenger side since I have the pcv valve, or can I get rid of it?
__________________
Engine:
1990 5.8 / Edelbrock Performer set-up
MSD ignition
Suspension:
Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors /
Drivetrain:
Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel /
5.8 in the hole
|