[rwhite65]

can the stock e7's run higher rpm's without pulling out one of the rocker mounts? I think I am going to run the stock cam in a 92 block for now, but I am not sure if I need to update the springs from stock and/or have the heads machined for sutd roller rockers.

the only reason this is an issue, is because this motor needs to still pull good aroun 6-7000 rpm range. The 4.10 gears have it revving hard across the quarter. Any help you guys can give is greatly appreciated. I have been told the stock cam will be fine with the 92 ho motor...ported e7te's, but am unsure about the valvetrain.
Ryan