Machining Costs
Does anyone know average prices for machining? Im probably gonna have my 106,000 mile shortblock rebuilt with a 306 engine kit from DSS. So I would like to have the blocked bored .30 over and everything that goes with that (decking, honing etc) I know this usually runs about 500-600 bucks. Also I would like to have my stock rods and crank shot peened as I really dont have the money or need to buy new rods. I was just going to buy a base bullet DSS shortblock but 200 dollars shipping is a bit of a waste IMO. Im going to be adding ported stock heads, ported edelbrock performer intake, a TFS stage 1 cam and 1.6 RR's to the top end so I wont be making huge power to necessitate really good rods.
The DSS 306 kit im talking about comes with DSS forged pistons, rings, bearing, freeze plugs and ARP rod bolts.
Thanks!
|