Hey, that looked like my wireing harness! If you dont have the $$$ to go for a new one or even a good used junkyard one, then repair is the last resort. I'd definitely go with a heavier guage wire. But not too much thicker. If you're going to the trouble to, do the repairs. Do it right. Solder everything! Then heat wrap the wires so you dont have them going bad on you again. I've patched mine, and so far(knock wood) have not had a problem. Good luck
__________________
1970 Stang Conv:
en:Boss351 (balanced/blueprinted)
mech cam(240*@.050/.540 lift)
Scrw in studs/comp cams rllr rkr
Mldn valves 2.19in 1.71ex
ported polished cc'd hrdnd ex
Keith Black FT pistons(10.25/1)
Weiand Excellorator manifold
Holley700 DP mech 2nds
MSD 6 box and Dis
Headers/2 1/2 inch duels
tr: modified FMX
re:9-inch/3.89 limited slip
|