MustangWorks.com : Ford Forums - View Single Post

netzaffe · 01-14-2005, 10:51 PM

Hey guys, i just installed my 289 engine back in my mustang with a new t5 tranny. I replaced the engine mounts during the install and im worried i dont have the engine in right, one of the mounts slit right in half, i think its because the tranny cross member was not in yet and it sagged a bit. Then im worried that i dont have the engine alligned properly, im having to make a plate just to mount the transmission to the crossmember. I need some measurments guys, let me know angles etc.

thanks

01-14-2005, 10:51 PM	#1
netzaffe Registered Member Join Date: Dec 2004 Posts: 4	engine install gone wrong Hey guys, i just installed my 289 engine back in my mustang with a new t5 tranny. I replaced the engine mounts during the install and im worried i dont have the engine in right, one of the mounts slit right in half, i think its because the tranny cross member was not in yet and it sagged a bit. Then im worried that i dont have the engine alligned properly, im having to make a plate just to mount the transmission to the crossmember. I need some measurments guys, let me know angles etc. thanks