Engine Dies?
This weekend i tired to break in my cam, but about 30 seconds into the break-in the motor died so i started it back up and brought up the rpms and 20-30 seconds into the break-in the motor died again. Im a little lost on where to go from here. If you can please help me out, Thanks.
I had the balancer at 30 degrees before top dead center then i dropped the distributor in with it a touch advanced.
my setup is: 351w: 10:8:1 compression
Mighty Demon 750 carb
Victor jr. intake
Victor jr. heads
comp cams hydraulic flat tappet: 250, 256 duration @ 50 degrees
554, 558 lift.
MSD billet distributor (21 degrees mechanical advance)
MSD 6a box
MSD coil
|