car won't start after head reinstall
Ok, long story short. Blew a head and intake gasket. Just finished putting the car back together last night. Installed the distrubutor at TDC with 1 facing 1. I have 2 different coil packs, one is a crane the other is the factory (the factory coil was already on there and always worked ), i also have an msd cap. The car is turning over and fuel system is working properly. Gapped my plugs to factory specs. I am not sure at all why it is not starting? Thinking it might've been the coil i changed them over, and still nothing. Every connection is connected where it should be, just reset the computer again and let the car sit for an hour thinking it might have been flooded. Any and all help would be appreciated. This car is my daily driver and the only car i have on the road during the summer.
__________________
1989 Mustang
5.0 Conversion, Full Saleen ground effects and spoiler, '94 saleen decal set, '93 Saleen Seats, Black interior from a '93, Steeda quadrant, smog pump delete, a/c delete, Steeda Tri-Ax shifter, '97 rear differential, aluminum driveshaft, 5 lug conversion, '97 rear disc brakes, southside upper and lower control arms, '99 GT Anniversary wheels, flowtech longtubes, flowtech offroad H-pipe, saleen lowering springs, kyb shocks, caster/camber plates
|