MustangWorks.com : Ford Forums - View Single Post

Hozer 88GTConv · 07-13-2005, 12:52 PM

To properly install the roller rockers, rotate the engine until the lifter is on the heel of the cam. While you're tightening the rocker, rotate the pushrod with your fingers. When you can't rotate it any further, the rocker is at zero lash. Then tighten the adjusting nut one-quarter to three-quarters turn. If you must turn the adjusting nut more than that, you must use shims to properly adjust the rockers.

07-13-2005, 12:52 PM	#2
Hozer 88GTConv Registered Member Join Date: Feb 2002 Location: Jacksonville, FL Posts: 706	Re: rocker adjustment To properly install the roller rockers, rotate the engine until the lifter is on the heel of the cam. While you're tightening the rocker, rotate the pushrod with your fingers. When you can't rotate it any further, the rocker is at zero lash. Then tighten the adjusting nut one-quarter to three-quarters turn. If you must turn the adjusting nut more than that, you must use shims to properly adjust the rockers. __________________ 1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy