MustangWorks.com : Ford Forums - View Single Post

GhettoPop · 08-08-2005, 01:44 PM

jester to do that i'm gonna need some really long screws but i guess its possible. i mounted it on a layer of rubber and then onto an aluminum rectangular base for support.

USMC- i was told that i could run into problems if installed in the car if i run all the wires through the same hole in the firewall. they will interfere with each other. is this true? i wanted to avoid running through the firewall if i can and i think the only place to mount is under a seat. MSD recommends installing it as close as possible to the coil and says NOT to mount in the glovebox. i guess cuz of heat.

08-08-2005, 01:44 PM	#6
GhettoPop Gimme a Drink! Join Date: Dec 2002 Location: NYC Posts: 694	Re: can u mount an MSD upside down? jester to do that i'm gonna need some really long screws but i guess its possible. i mounted it on a layer of rubber and then onto an aluminum rectangular base for support. USMC- i was told that i could run into problems if installed in the car if i run all the wires through the same hole in the firewall. they will interfere with each other. is this true? i wanted to avoid running through the firewall if i can and i think the only place to mount is under a seat. MSD recommends installing it as close as possible to the coil and says NOT to mount in the glovebox. i guess cuz of heat. __________________ 1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong!