pushrod length
I'm planning on upgrading to a new set of 1.7 rocker arms and figured I might as well replace the stock pushrods. The problem is that I'm running into different size pushrods available for the roller cams. Comp Cams has a set that are 6.250, Ford Racing has a set that are 6.272, and Crane has a set that's 6.258 inches long. I would think that the Ford racing rods would give the stock cam with 1.7 rockers would be a good combo with my Comp Cams valve springs. But I'm worried about too much valve lift, and piston to valve clearence..
If anyone has any input I'd greatly appreciate it....
Thanks
__________________
95 GT convertable, ported+polished GT40 heads, port matched upper and lower Cobra intake manifold, Flowthech headers, Catco hi-flow h-pipe with 2 hi-flow cats, Mac true fit catback exhaust, 3.73 gears, underdrive pullies, Edelbrock 70mm throttle body, Mac cold air intake, FMS 24lb injectors, Granatelli 75mm mass air
|