MustangWorks.com : Ford Forums - View Single Post - Getting EEC codes with new heads/cam/intake install

Udelose · 11-14-2005, 04:28 PM

Finally got my bbk ssi intake in and installed it this weekend along with edelbrock performers and E303cam. It seems to be running fine, but I am getting check engine light on. I did not rehookup my heater hose on the lower intake So now I am getting a code 98 and 51(Engine coolant Temerature sensor voltage). How can I fix this without hooking my heater pipe back up, and will this cause the computer to run in failure mode? These are the only two codes I am getting....

11-14-2005, 04:28 PM	#1
Udelose Registered Member Join Date: Nov 2005 Posts: 1	Getting EEC codes with new heads/cam/intake install Finally got my bbk ssi intake in and installed it this weekend along with edelbrock performers and E303cam. It seems to be running fine, but I am getting check engine light on. I did not rehookup my heater hose on the lower intake So now I am getting a code 98 and 51(Engine coolant Temerature sensor voltage). How can I fix this without hooking my heater pipe back up, and will this cause the computer to run in failure mode? These are the only two codes I am getting....