MustangWorks.com : Ford Forums - View Single Post

Gearhead999 · 11-27-2005, 07:47 AM

The AOD had a bushing in the rear of the tail housing that the driveshaft yoke runs on.

They make a tool that goes in from the seal side and grabs it so you can pull it out that way. It doesn't always work.

The other way is to remove the tail housing and remove and replace the bushing with it on the bench.

11-27-2005, 07:47 AM	#3
Gearhead999 Registered Member Join Date: Sep 1998 Location: Oviedo, FL Posts: 992	Re: aod tailshaft bearing replacement The AOD had a bushing in the rear of the tail housing that the driveshaft yoke runs on. They make a tool that goes in from the seal side and grabs it so you can pull it out that way. It doesn't always work. The other way is to remove the tail housing and remove and replace the bushing with it on the bench. __________________ "Support our Troops" Dave 1968 Cougar 2004 Thunderbird 2007 F150 Harley-Davidson, SuperCrew 1986 LTD 1997 Ranger 1992 Honda Civic