[Rev]

I have a set of 351W heads that I ran for several years on my 306 engine. The only reason that they were removed was because I wanted TFTW aluminum heads.

The 351W heads were used for about 20,000-25,000 miles over a 4 year period. These heads are professionally pocket ported and gasket matched with a 3 angle valve job. The valves measure 1.85 intake/ 1.55 exhaust. The heads were angle milled to produce a 59.5 cc chamber. With flat top pistons that should make 9.5/1 CR on the 302. These heads also include Comp Cams 1.6 ratio roller tip Magnum rocker arms ($139 value new).

About a year ago, I thought I had the heads sold. At that time, I took them back to the shop that built them originally. They were disassembled, cleaned, and inspected at that time. No problems were found. They did do a touch up vave job just because they had them apart.

I would sell these heads for $400 + shipping. Pm me for further questions if interested. BTW. I think my 306 made approximately 300 HP with these heads.

Rev