Re: pulled codes, please help
This may be a dumb question at this point, as I am coming in at the halfway point.
Have you cleaned the MAF sensor?
Some say to use Q-tips and a solvent (usually Windex or Alc), but I prefer to spray the 2 wires with brake cleaner. Brake cleaner will not leave a residue behind, unlike most solvents, plus the wires are fairly sensitive to stretching (resistance changes), so I have no desire to touch them with anything.
C&L should be able to tell you if the 2 sensors you are using are the same/interchangeable.
Good Luck,
jason
__________________
Check out my new Mustang website! - Including: TwEECer, EEC-IV, C&L, 351w Fox Swaps, PCV Oil Control, and more.
1990 GT - 408w - 17mpg
TwEECer RT 1.30A10 - X3Z - A9L strat. / EA
Forged Bottom End / Gapless Rings / CR 8.85:1 / Custom Cam / Ported Trick Flow Heads / Box Upr / Lightning Lwr
17x9 Cobras / Front 255s / Rear 275s / 5 Lug Cobra Disc Conversion / Auburn Ltd. Slip / 3.27 / 31 spline axles / Panhard Rod / Upr&Lwr Control Arms
1987 Red LX - 2.3L - Planning 2.3t Converison
|