MustangWorks.com : Ford Forums - View Single Post

Rayabear · 04-26-2006, 05:25 PM

I've been doing alot of heavy body mods to my SN95 '96 GT getting ready to paint. I glassed in and bondo'd sidescoops, and shaved the door handles. Now I'm installing the Invader body kit I got off ebay and the fit is terrible. I knew I had to mod the sideskirts because they have sidescoops in them I didn't like, but the front fit where the front/bottom fender meets the kit has about 3/4" space that lloks like crap! Did anyone out there install this kit? What did you do about the gap? The only thing I can think of is to split the tab where the bolts go through, increase the angle and glass it again, but I'm not even sure if that will work. ANY suggestions would be more than welcome.

Ray

04-26-2006, 05:25 PM	#1
Rayabear Prison Cop Join Date: Apr 2006 Posts: 8	Trouble installing a body kit. I've been doing alot of heavy body mods to my SN95 '96 GT getting ready to paint. I glassed in and bondo'd sidescoops, and shaved the door handles. Now I'm installing the Invader body kit I got off ebay and the fit is terrible. I knew I had to mod the sideskirts because they have sidescoops in them I didn't like, but the front fit where the front/bottom fender meets the kit has about 3/4" space that lloks like crap! Did anyone out there install this kit? What did you do about the gap? The only thing I can think of is to split the tab where the bolts go through, increase the angle and glass it again, but I'm not even sure if that will work. ANY suggestions would be more than welcome. Ray