MustangWorks.com : Ford Forums - View Single Post

surfsup · 06-22-2006, 10:11 PM

Thanks for the info, I looked over the gasket section, the heads I have are used, and I’m guessing that the owner had ported the heads to a 1262 felpro because the gasket seem to fit perfect, no runners are exposed, or very little if any and that could be from not having it sit right on the heads, what I’m concerned about is will I have the gasket positioned correctly on the intake so when I’m done the ports line up, the other thing that bothers me is the amount of material I have to remove from a manifold that’s suppose to used with high performance heads, the ports seem very small. I have been calling edebrock but the line is always busy, plus I have sent several e-mails but have yet to hear anything.

06-22-2006, 10:11 PM	#3
surfsup Registered Member Join Date: Sep 2004 Location: jersey Posts: 147	Re: Gasket matching porting, Thanks for the info, I looked over the gasket section, the heads I have are used, and I’m guessing that the owner had ported the heads to a 1262 felpro because the gasket seem to fit perfect, no runners are exposed, or very little if any and that could be from not having it sit right on the heads, what I’m concerned about is will I have the gasket positioned correctly on the intake so when I’m done the ports line up, the other thing that bothers me is the amount of material I have to remove from a manifold that’s suppose to used with high performance heads, the ports seem very small. I have been calling edebrock but the line is always busy, plus I have sent several e-mails but have yet to hear anything.