MustangWorks.com : Ford Forums - View Single Post

surfsup · 07-09-2006, 06:23 PM

Well I discovered I had more sensor wire after I took the cover off the top, it was tucked in there pretty good, I originally had the sensor on the side of the fan tucked under the rubber seal to hold it, I didn’t want to set this on the top fins in case the radiator ran low and then I wouldn’t get the right reading, since I found the extra length I still have the sensor on the side but away from the fan and I fed it through the fins, so it’s sticking about half way into the radiator, not crazy about the way it looks so I might lay the sensor flat against the radiator and use the wire ties that came with it.

07-09-2006, 06:23 PM	#5
surfsup Registered Member Join Date: Sep 2004 Location: jersey Posts: 147	Re: profourm fan help Well I discovered I had more sensor wire after I took the cover off the top, it was tucked in there pretty good, I originally had the sensor on the side of the fan tucked under the rubber seal to hold it, I didn’t want to set this on the top fins in case the radiator ran low and then I wouldn’t get the right reading, since I found the extra length I still have the sensor on the side but away from the fan and I fed it through the fins, so it’s sticking about half way into the radiator, not crazy about the way it looks so I might lay the sensor flat against the radiator and use the wire ties that came with it.