MustangWorks.com : Ford Forums - View Single Post - Made up my mind-347 plans starting

todd95GT · 10-02-2001, 04:49 PM

Ok, was talking to my engine builder today. Great guy. After the 4.10's go in in the next couple of weeks, I'm going to start stockpiling parts for a 347 stroker. I would like to add the heads and intake to the 302 in the meantime, but get parts that will be compatible with the larger motor when the project is built and it's ready for the swap. I'm set on AFR heads. Do you guys think 185's for the 347? If so, do you think they'd be too much for the 302 in the meantime. No way in hell I'm spending a grand twice. Just looking for your opinions. I think I'm going with an Edelbrock Performer 5.0 intake.

------------------
Todd
1995 GT/T-5
Pulleys; 65 mm TB; Flowmaster cat-back; Mac off road H-pipe; FMS aluminum driveshaft; short-throw shifter; HD clutch; Cobra R's; Cobra front and wing

10-02-2001, 04:49 PM	#1
todd95GT Registered Member Join Date: Aug 2001 Location: Palm Beach Gardens, Florida, USA Posts: 191	Made up my mind-347 plans starting Ok, was talking to my engine builder today. Great guy. After the 4.10's go in in the next couple of weeks, I'm going to start stockpiling parts for a 347 stroker. I would like to add the heads and intake to the 302 in the meantime, but get parts that will be compatible with the larger motor when the project is built and it's ready for the swap. I'm set on AFR heads. Do you guys think 185's for the 347? If so, do you think they'd be too much for the 302 in the meantime. No way in hell I'm spending a grand twice. Just looking for your opinions. I think I'm going with an Edelbrock Performer 5.0 intake. ------------------ Todd 1995 GT/T-5 Pulleys; 65 mm TB; Flowmaster cat-back; Mac off road H-pipe; FMS aluminum driveshaft; short-throw shifter; HD clutch; Cobra R's; Cobra front and wing