[Dark_5.0]

Originally Posted by HotStang89

Just wondering if anyone has ever had a similar application on their car without having to worry about clearance? I am getting ready to
install an F303 Cam, a set of J302 heads milled to
54cc with 1.6RR on an 89 stock bottom end?

Thanks

I dont know how much your heads were milled but I think it will clear. Use some clay and check the clearance, this is one area where its way better to be safe than sorry.

My heads are 54cc and I ran the F303 but valve angels and depths vary between heads.

Hope I was of some help.