MustangWorks.com : Ford Forums - View Single Post - Ready to replace bearings and install cam......What's a good spec??

PKRWUD · 10-18-2001, 09:34 AM

Comp Cams #32-225-4:

Magnum Hydraulic
Operating range: 2000 - 6000 rpm
Duration (@.050") 230/230
Lift: .530/.530
Lobe sep angle: 110 degrees

"Good in street machines, mild conv., headers and gears. 9:1 - 10:1 comp. Rough idle."

It's significantly bigger than the one it's replacing, but still quite drivable.

Something just occured to me... Is your block a 351C or a 351W?

------------------
Retired Moderator
MustangNet

My site: Peckerwoods Pit Stop

My teams site: Jim Porter Racing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN.

10-18-2001, 09:34 AM	#9
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	Comp Cams #32-225-4: Magnum Hydraulic Operating range: 2000 - 6000 rpm Duration (@.050") 230/230 Lift: .530/.530 Lobe sep angle: 110 degrees "Good in street machines, mild conv., headers and gears. 9:1 - 10:1 comp. Rough idle." It's significantly bigger than the one it's replacing, but still quite drivable. Something just occured to me... Is your block a 351C or a 351W? ------------------ Retired Moderator MustangNet My site: Peckerwoods Pit Stop My teams site: Jim Porter Racing RACECAR spelled backwards is RACECAR HEY !!! Are you ASE Certified ??? If you are, ask me about iATN.